Model car 3-channel LED light switch panel, Insert the servo plug of the remote control board into the third channel of the receiver, then remotely control the light switchEasy to use installation and operation. Control LED lighting / flash / switch, Suitable for all 3CH controllers, using the controller's 3-channel function buttons to control the light2 circuits, one cable can control two sets of LEDs, The controller can not only turn the LED light into a headlight, a taillight, a turn signal or a flash, but also control two LED lights at the same time.They are powered directly from the receiver and are very easy to use.Stable performance, practical and durable. Need to use the third channel function button for remote control! The board has a boost regulator. Can bring 12 5mm led lights.Upgraded mode of operation:Each time the third channel switch is toggled twice or the third channel button is pressed twice,the cycle changes in the following order:2 output off - Greater than A output is open, B output is off - Greater than A output is off,B output is on - Greater than 2 output is on - Greater than 2 light breathing flash mode - Greater than 2 output off..cycleSpecifications:Use voltage: 4.8~6VHow to use: Connect the servo connector to the receiver's third channel (CH3)Cable length: 190mmMaterial: compound materialcolour: As shownPackage Contents:3 x Model car LED light control panelOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.