This is a super portable passive HF/VHF loop antenna designed for super low /MDS receivers like the Airspy HF+ . It also works to some extent with the RTL-SDR V3 in direct sampling mode if you enable RTL AGC. But for radios without super low MDS specs, the signals can be boosted on by using any external low cost HF amplifier, or even our wideband LNA. The YouLoop design is based on the Mbius loop idea where a balanced electric shield is used as the center of a multi-turn loop. The rest of the turns run inside the shield. This construction is electrically balanced for large wave wavelengths, ie. when is very large compared to the size of the antenna. This helps cancelling the electric noise at the lower bands, exactly where most of the electric noise energy is concentrated. To preserve this electric balance from alteration by the transmission line, a low loss miniature BALUN is used. Therefore this is NOT a resonant antenna, hence the requirements for very low MDS radios or an amplifier. Specification: HF Response: 10kHz to 30 MHz VHF Response: up to 300 MHz Maximum Power: 250 mW Feedline Length: 6m (SMA male to male) Features: Passive design No tuning required Low-loss wide-band BALUN with 0.28 dB loss typ. Colour: blue + white + black Material: ABS + metal Size: 60 x 36 x 20mm Package Contents: 1 x T-shaped BALUN 1 x phase inverter 2 x 1m RG402 coaxial cable 1 x 6m RG174 coaxial feeder Note: This antenna is designed for portable use and is not weatherproof. Permanent mounting can be achieved with weatherproofing tape. Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.