<p>The PM02 is an to provide your and Pix32 with clean power from a LiPo battery as well as current draw and battery voltage measurement via a 6-position cable</p> <p>Onboard switching regulator outputs 5.2V at 3A for up to 10S LiPo batteries</p> <p>The power module comes fully assembled with XT60 connectors and wrapped in shrink tubing for protection</p> <p>The power module is designed to power , Pix32, RC receivers and accessories (GPS, radio). It is not designed for servo power</p> <p>GH terminals are also compatible with for Pixhawk4 and for Pixhawk4 mini</p> <p>Maximum input voltage: 60V</p> <p>Maximum current sense: 120A</p> <p>Configured for 5V ADC for voltage and current measurements</p> <p>BEC regulated output 5.2V and 3A maximum</p> <p>6-position Molex cable plugs directly into \/Pix32's 'PM' connector</p> <p>6-position GH cable plugs directly into Pixhawk4\/Pixhawk4 mini 'PM' connector</p> <p>(Due to different batches, the printed words on the product be different, which does not affect use)</p> <p>Colour:As Shown</p> <p>Material:plastic</p> <p>Package Contents:</p> <p>1 Module</p> <p>1 x Molex 6-position cable</p> <p>1 x GH 6-position cable</p> <p>1 x English manual</p> <p>Only the above package content, other products are not included.</p> <p>Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.</p>