DIAG BOX V9.85 Important note: (The old K-line before 2000 does not support it) The vehicle coverage is approximately 2005- Important reminder: Standard configuration V7.83 and V9.85 software. V7.83 is installed on WIN732-bit systems, while V9.85 can be installed on WIN7 and WIN10. (Both versions of the software support for and for ) Features supported by 3 PP2000: Different from other scanning tools that only read fault codes; This software performs almost all functions similar to the old diagnostic tool. Our diagnostic interfaces include CAN line multiplexers, CAN-BUS interfaces, and SAE J1850 buses. Read Identification Displays complete identification of control unit, e.g. part number, software/hardware version, manufacturer, etc. Read Fault Codes Displays all stored and pending fault codes with complete description (e.g. "Rail pressure - too low pressure").Program supports report printing or copy to clipboard.<br><br>Clear Fault Codes - This function clears all stored fault codes and other diagnostic information. Auto-Scan (Complete Car Scan/Test) - Detects all ECUs (electronic control units) installed in car and reads all diagnostic fault codes. Measured Values - Program displays live Data like Engine Speed, Battery voltage, Oxygen Sensor, Coolant Temperature, et Car coverage: 1. P2000, 3 is compatible with most for cars from 2005. 2. PP2000, -3 is implemented through the OBD II connector (located near the steering wheel) or manufacturer specific connector (only for vehicles after 2005) For C-Zero/C1/C2/C3/C3 /DS3/C-ELYSEE/C4/C4 CACTUS/ C4 /DS4/ 5LS/C5/DS5/C6/C8/C-CROSSER/C4 //BERLINGO/JUMPY/JUMPER/AX//BX//XSARA/XANTIA/XM/EVASION/C15/FUKANGFUKANG 988/ELYSEE/C-ELYSEE(R3)/C-TRIOMPHE/C-QUATRE For iON/107/108/206/207/207+/280/301//307//RCZ/407/408/508/607/807/1007/2008/3008/4007/4008/5008/BIPPER/PARTNER/EXPERT/106/205/306/309/405/406/605/806 Due to different batches, the