Description for Mini One Cooper S Convertible R52 (2001-2006) rear hood soft top weather rubber seal repair self adhesive. This product is a DIY rubber repair solution for the rear weather seal on the Mini Convertible R52. It replaces the rubber strip located above the chrome trim that runs along the rear of the roof, above the boot and quarter panels. This area is prone to aging, cracking, and sun damage over time. The seal is made from self-adhesive rubber with 3M tape backing and measures approximately 2 meters in total length. Minor trimming may be required to fit around the third brake light and to match the exact length needed. Installation Instructions: Step 1: Clean the surface thoroughly to ensure maximum adhesion. Remove all remnants of the old rubber seal down to the plastic surface using a sharp craft knife or similar tool. Step 2: Position the new rubber strip over the prepared area, aligning it with the flat edge where the old seal was removed. Apply the strip so it slightly overlaps onto the roof material for optimal sealing. Note: Proper alignment is critical as adhesive bonds quickly. For added security, apply a small amount of super glue (not included) in concealed areas to prevent lifting due to movement. Alternatively, a bead of silicone can be used if necessary. This repair helps restore the weather seal, protects ing from UV exposure, and improves the appearance of the roof. The design includes a slight increase in rubber size where it overlaps the chrome, providing a durable and visually improved finish. A real-world example of this repair was completed in December 2020 on an R52 and has successfully endured multiple UK seasons, including winter conditions and summer weather. Care Tip: Avoid pressure washing the roof or seal. Clean gently with a sponge and water, then rinse with a bucket. For easier installation, it is recommended to remove the chrome trim to access the area safely. Tamper-proof Torx screws are located underneath the chrome strip and can be accessed by releasing the side latches (boot loading mode), allowing the lower roof section to be lifted. Support the roof with a suitable prop during work. Package Includes: 1x replacement self-adhesive rubber seal