Product Introduction: The MKS CAN V2.0 module is an upgraded version of the MKS CAN V1.0. It is a compact, low-cost, open-source USB-to-CAN analyzer. The device enumerates as a virtual serial port on your computer and functions as a serial interface for the CAN bus. The CAN 2.0 supports standard CAN 2.0A, CAN 2.0B protocols. When using candleLight firmware, it appears as a native CAN interface on Linux systems. The analyzer is compatible with ARM-based embedded platforms such as Raspberry Pi, Raspberry Pi Zero, ODROID, BeagleBone, and others, making it suitable for integration into various products. Product Features: 1. Supports CAN 2.0A and CAN 2.0B with baud rates up to 1 Mbps. 2. Compatible with candleLight and slcan firmware; slcan supports higher test baud rates up to 2 Mbps or 5 Mbps. 3. Terminal resistor can be enabled or disabled via jumper shunt. 4. Equipped with Type-C USB interface; supports online firmware upgrade and DFU mode firmware update. 5. Built around a high-performance ARM Cortex-M4 STM32G431C8T6 processor with operating frequency up to 170 MHz. 6. Schematic diagrams, firmware, source code, and host software are provided, ensuring complete and accessible documentation. Analyzer Board Version: V2.0 Material: ABS Color: As shown in image Package Contents: 1 x USB data cable 1 x 3-pin double cable 1 x Analyzer board Note: Light reflection and differences in display screens may cause slight variations between the color shown in the image and the actual product. Measurement tolerances may vary by +/- 1-3 cm.