Equipment: 100*Tile Leveling System Floor Kit Feature: 1. Wear-resistant, recyclable and reusable. 2. The DIY operation is simple and easy to use. 3. Balance the tiles in the same horizontal position. 4. Improve tiling speed. 5. Reduce installer fatigue/stress. 6. There is almost no flat, crack-free surface. 7. This reduces the need for sharpening and polishing. 8. Prevent the shingles from moving during the solidification process. Feature 1 pack 50pcs, 1 wrench, needle thickness 1.5MM A total of 100 pieces Weight: 0.56kg/bag (with some error) Skills Lay the first tile leaving more than 2mm ( with cross stitching). Near the tiles. Insert a T-pin next to the space between the tiles. Then rotate it 180 degrees to connect the T-pin at the bottom of the two tiles. Adjust the cover by hand/special wrench until the two tiles are level. After leveling for about 5-6 hours, before the cement/adhesive is completely dry, turn the cover in the opposite direction and pull the T-pin 180 degrees until the dirt is removed. Avoid not removing the T-shaped leveling tile system 1. Tile joints greater than 2 mm (cross joints are recommended) 2. When leveling, the adhesive or tile adhesive around the T-type leveling machine should be cleaned. 3. About 5-6 hours after leveling, remove the T-type trowel before the tile or cement adhesive is completely dry. 1. Due to the difference in the display and lighting effects, the actual color of the product may be slightly different from the color shown in the picture. Thanks 2. Due to manual measurement, please allow slight measurement deviation.