Item Type: Stepper motor driver Model: TB6600 upgraded version DC Power Supply: 9V-40V DC power supply Eight Kinds of Output Current Available: Maximum 4.0A 6 Subdivision Modes Available: 32 subdivisions Standard Common Positive Single Pulse Interface: Yes Offline Hold Function: Support Protection: Built-in temperature protection and overcurrent protection Weight: Approx. 201 g / 7.1 oz Applicable Stepper Motors: 42, 57 and 86 type 2 phase 4 phase (4-wire 6-wire 8-wire) Definition of Terminal: Signal Input: CP+: Pulse signal input positive terminal. CP-: Pulse signal input negative terminal. DIR+: Positive end of motor forward and reverse control. DIR-: The negative end of the motor's positive and negative control. Enable+: Positive end of motor offline control. Enable-: Motor off-line control negative terminal. Motor Winding Connection: A+: Connect the A+ phase of the motor winding. A-: Connect the A-phase of the motor winding. B+: Connect B+ phase of motor winding. B-: Connect B-phase of motor winding. Working voltage connection: Volt Current Condenser: DC power supply is positive (note: 10V VCC 42V). Ground: Negative DC power supply Signal Input: Optocoupler isolation connection Two Connection Methods for Input Signal Interface: The user can adopt the common anode connection method or the common cathode connection method as needed. 1. Common Anode Connection Method: Connect CP+, DIR+ and EN+ to the power supply of the control system respectively. If the power supply is +5V, it can be directly connected. If the power supply is higher than +5V, an external current limiting resistor R must be added. To keep that the drive current of 8-15mA is provided to the internal optical coupling of the driver. The pulse input signal is accessed through CP- at this time, DIR- and Enable- are active at low level. 2. Common Cathode Connection: Connect CP-, DIR-, Enable- to the ground terminal of the control system (SGND, isolated from the power ground) the +5V pulse input signal is added through CP+ at this time, DIR+, Enable+ are in Active high. The connection value of the current limiting resistor R is the same as the common anode connection method.1Stepper motor driver's quiescent current will be automatically halved and it is with 8 available output currents, which can be up to 4. 0A. 2With built-in temperature protection and overcurrent protection, motor driver supports H-bridge bipolar constant-phase flow drive. 3As the upgraded version of TB6600, the subdivision is increased to 32 subdivisions, suitable for high subdivision purposes. 4Keeps input signal high-speed photoelectric isolation, driver board provide energy-saving semi-automatic current lock function. 5The semi-closed casing can adapt to more severe environment. And this driver board keeps simple installation. 1 x Stepper Motor Driver