Feature:1. The product is made of zinc alloy, which is rust-proof, impact-resistant, wear-resistant and durable.2. It has the advantages of simple operation, allowing you to easily and quickly repair the dent.3. High gasket strength, high hardness, not easy to be damaged or broken, it is reusable and reliable to use.4. Perfect for different dents and hail damage, suitable for all pulling glue devices, such as slide hammers, dent puller, etc.5. Wide range of use, suitable for dent repair of solar panel, automobile, motorcycle, washing machine, etc.Specification:Condition: 100% Brand NewItem Type: Dent PullerMaterial: Zinc AlloySize (As Shown in Picture): Approx. 3.5cm / 1.4in, 3cm / 1.2in, 2.5cm / 1.0in, 2.2cm / 0.9in, 2.7cm / 1.1in, 3cm / 1.2in, 2cm / 0.8in, 3.2 x 1.6 cm / 1.3 x 0.6 inWeight: Approx. 120g / 4.2ozHow to Use This Paintless Dent Repair Kit?1. Clean the dent with a clean wet cloth;2. Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;3. Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;7. Check with a line board. If dent still exists, knock it slightly with a flattening hammer or pen;8. Clean the repaired place with a clean wet cloth..Package List:8 x Dent PullerNote:It is necessary to cooperate with the hammer, glue gun and glue stick to be used normally.