YX-X801 module, protection against complete discharge of 12V battery The YX-X801 module allows you to set the minimum voltage at which the relay is opened, protecting the battery from discharge below the set voltage. The module also ma the ability to set the upper voltage limit at which the relay ma be closed, and the same voltage as the battery will appear at the module output. The device is equipped with an XH2.54 connector, which is used do to call the relay switch on at any time while the relay is switched off (it was not switched on after exceeding the upper limit voltage). The system has a LED diode informing about switching on the relay. If the relay is switched off and the ON-SW output is shorted, the relay contacts will be closed, while after opening them, the relay contacts will be opened. Specification: 12V Battery Discharge Controller Module Electronic module with relay: YX-X801 Supply Voltage: 12V DC Voltage Error: 0,1V Maximum relay current: 10A Relay switching voltage: start of the charging process Relay shutdown voltage: voltage on the battery has fallen below the set lower limit LED indicating output operation Potentiometers do regulation of initial and final voltage Connects terminal block ARK do screw wires Relay: SRD-12VDC-SL-C Maximum load on relay contacts: 10A 250VAC or 10A 30VDC Dimensions: 50x30x18 mm