3‑pin extension cable for mid‑drive brake levers, thumb throttle, and gear sensors — 22" (56 cm) Why you need this cable - Extends the reach of 3‑pin control cables so you can place brake levers, thumb throttles, or gear sensors where they are most convenient. - Prevents strain on original wiring and connectors when components must be routed farther from the controller. - Keeps system wiring tidy and functional without replacing existing components. Key benefits - Simple plug‑and‑play extension for mid‑drive systems that use 3‑pin connectors. - Maintains connector orientation and contact order to preserve signal function between component and controller. - 22" (56 cm) length provides extra routing flexibility without excess slack. What it does and how it solves problems - Extends the physical distance between a 3‑pin accessory (brake lever, thumb throttle, gear sensor) and the controller, solving reach and routing issues on larger frames or custom builds. - Reduces stress on original cables and connectors, lowering the risk of intermittent signals or connector damage. - Enables cleaner cable management by allowing more direct routing paths. Compatibility and function - Designed for 3‑pin connector systems used with mid‑drive brake levers, thumb throttles, and gear sensors. - Intended as an extension only; use with compatible 3‑pin connectors on your existing components and controller. Size and performance - Cable length: 22" (56 cm) — long enough for most routing adjustments while minimizing extra cable loops. - Provides reliable signal continuity between the accessory and controller when used with matching 3‑pin connections. Practical use scenarios - Moving your controller to a different location on a full‑suspension bike where existing cables are too short. - Installing an aftermarket thumb throttle on a step‑through frame and needing extra length to reach the controller. - Replacing a damaged short pigtail on a mid‑drive brake lever without changing the original lever or controller. Installation notes - Match connector orientation and pin count before connecting; intended for 3‑pin systems only. - Ensure connectors are fully seated and protected from moisture and debris according to your system’s existing installation practices. Specification - Connector: 3‑pin - Compatible with: mid‑drive brake levers, thumb throttle, gear sensors (3‑pin) - Cable length: 22" (56 cm)