LCR-TC1 TC1 Colorful Display Multifunctional TFT Backlight Transistor Tester For Diode Triode Capacitor Resistor Transistor Note: In order to protect the safety of your product, the test capacitor must be discharged first to avoid electrostatic breakdown of the chip and burn the product. Feature: Self test with automatic calibration Size: 70*90*26m/ 2.71x3.58x1.10 inch Display:TFT Screen, Color Screen Diode Range: le than 4.5V Zener Diode:Transistor Detect Area: 0.01-4.5V Zener Diode Detect Area: 0.01-30V Triac Range: IGT le than 6mA Capacitance: 25pF-100mF Resistor: 0.01-50M Inductance: 0.01mH-20H Power Voltage: 3.7V Power: Built-in Rechargeable Lithium Battery Measurement results using TFT graphic display (160x128) One-button operation Auto power off (timeout setting) Built-in high-capacity rechargeable lithium-ion battery Lithium-ion battery voltage detection Support Chinese and English Warning: Built-in lithium-ion battery, it is strictly forbidden to immerse the tester in water or near heat source! Warning: For your personal safety, please strictly observe the specifications and precautions for using lithium-ion batteries! Transistor Detection: After the power-off state or test is completed, put the test component into the transistor test area of the test socket, pre the lock handle, pre the multi-function key, the tester automatically measures, and the measurement result is displayed at the end of the test. Warning: Always discharge the capacitor before connecting them to the tester! The tester may be damaged before you turn it on! Warning: We do not recommend using a tester to measure the battery! The battery voltage must be le than 4.5V, otherwise the tester may be damaged! Component placement: The test socket is divided into transistor and Zener diode test areas, as described in 1.1. Note: Do not perform other operations during the calibration proce to avoid affecting the calibration accuracy! Packing List: 1 x multifunction TFT transistor tester 1 x electronic component group (sent random) 3 x test hook Short the three test sockets, pre the multi-function button shortly, and the tester will automatically calibrate. No other operations are required after disconnecting the short wiring according to the prompt during the calibration proce.