Item Type: Immobiliser Emulator After decoding of for Renault computer using for RENAULT RESET TOOL or by entering security code, in most cases you can start engine, but some of computers can not operate without immobilizer code stored in their memory. Crude oil EDC15C3, DCU3R and MSA15, petrol SIRIUS32 (except those for 1.4Lengine) and FENIX5 for 2.0L 16V engine require working unlocked (with good key) immobilizer unit or for Renault immobilizer emulator. Fitment: Fit for Renault models, fitted with single-data-wire coded immobilizers. I.E.from 1994 approx. until the introduction of CAN (2001 to 2003, dependingon exact model). Immo pin code is not required Decode the ecu using the for renualt ecu decoder. Only 3 wires to connect: Ignition, Ground and Data. Small module size Module is designed to be left permanently connected to the car. Non-volatile memory means no data loss, even after flat batteries or for jump startS. Module can be used again if need be. Petrol ECU's For SIEMENS FENIX3B For SIEMENS FENIX5 For SIEMENS SIRIUS32 For SAGEM SAFIR (55pin) For SAGEM SAFIR2 (35pin) For BOS CH. MOTRONIC MP7.0 For MAGNETI MARELLI IAW 06R For MAGNETI MARELLI IAW 8R.30 For Diesel ECU's For BOS CH. MSA15.5 (DTI) For BOS CH. EDC15C3 (DCI) For LUCAS DCU3R (1.9D) Coded fuel cut-off valve (1.9D DDS) rcuit. Turn ignition back on, the car should now start. Colour: as shown Material: Plastic Package Contents: 1 x Emulator Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.