Type of power supply AC powerWeight 1.5 (kg)Maximum torque 30 (NM)Scope, Drilling and installation of screws, household use220V power supplyScrewdriver typeNominal speed 3000 (rpm)Bidirectional rotation directionTotal length 120 (mm)Vacuum speed 3000 (rpm)Handle type gun typeMaximum screw diameter 10Drive shaft / mandrel 4Nominal input power 00 (W)Rotation speed 600 (rpm)Tightening torque 3080x80 (mm) dimensionsSelf-compliant electric drill classificationForet specifications RightInstructions for power tools When using electrical tools, in order to reduce accidents such as fires, electric shocks and injury, you must pay attention to x basic safety elements listed below; Please read carefully the following security features before continuing.1. Keep the workplace clean and do not use electrical tools in workplaces and messy work surfaces.2. Do not use electrical tools in dark and wet locations. Keep it out of the rain. Do not use in combustible liquids or where combustible gases exist.3. Do not leave the children and idle on the workplace. The rollers do not allow rollers to approach tactile tools or power cables.4. When the power tool is not used, it must be stored in a dry place and out of the reach of children, and must be locked.Keep5. Keep an appropriate speed and pressure speed to make the tool operation safer and more durable.6. Operate according to the specified application range and do not exceed compliance for overload processing purposes.7. You must maintain a good posture when working, you have to stay firm and you do not have to stretch your hands on the tools to take things.8. The knives must be lubricated and replaced from time to time to keep them sharpened. Check the wires regularly. In case of damage, repair the handle and keep it clean.9. When the tools are not used or for maintenance, when you change the devices and knives, make sure you disconnect the power plug.10. Check before turning on the switch to run the machine. It is necessary to check whether the cutting tools of the cutting piece and the fastening key are completely removed. This habit must be cultivated.11. To avoid accidental startup, you must check if the tool switch is turned off before inserting the plug into the power source. After turning on power, do not frequently press your finger on the switch.12. Exterior extensions, when using tools outside, be sure to use external extension cords.13. Do not wear ample clothing or accessories to avoid tangling when the tool turns. Rubber gloves and non-slip industrial safety shoes should be worn outside. Protective cap.14. Use safety glasses and wear a mask when there are too many chips and dust.15. Do not turn on the wire, do not slide the wire moving tool and avoid touching the hot object and the cutting metal edge or the grease.16. Secure the room. Use tongs to secure the piece to cut, which is safer than holding the room by hand.17. When repairing or replacing parts, be sure to use the parts specified by the original plant and send them to a professional replacement repair center.18. Pay attention to the workpiece and tool in unison. Tools should not be used in case of fatigue.19. Before using the tool, you must carefully check if the tool cover or other parts are damaged and check if the degree of damage will affect the normal operation of the tool. Check if all moving parts are in the correct position, if the parts are fixed, etc. Do not use a power switch that does not work properly to activate the tool.20. During the work, your body should not come into contact with grounded metal objects, such as iron pipes, radiators, refrigerators, etc.