1. Latest ELM327 version for improved Ford compatibility 2. Modified design includes a switch to connect to different CAN buses 3. Designed for use with FORScan software 4. Compatible with software applications: FORScan, Elmconfig (supports Baud rate: 34800, please verify before ordering), FF2, and FoCCCus, among others Basic Features: Reset fault codes, trouble codes, and parameter IDs (PIDs), change vehicle configuration data, run diagnostic tests, and perform service procedures Supports MS CAN bus and HS CAN bus ELM327 USB 25k80 with switch for Ford diagnostic cable Product Introduction: This ELM327 OBDII USB cable features a switch and is designed for use with Ford and Mazda vehicles. When used with compatible software, it can detect modules not accessible to standard OBD2 scanners. It enables viewing of trouble codes, PIDs, and performing advanced tests and service procedures not available with standard OBD2 tools or basic ELM327 devices. Pin Configurations: Switch outside: HS CAN – uses pins 6 and 14 Switch inside: MS CAN – uses pins 3 and 11 Supported Software: FORScan Elmconfig (supports Baud rate: 34800, please verify before ordering) FoCCCus Modified ELM327 Information: Many Ford and Mazda models from approximately 2003–2004 onward are equipped with an MS CAN bus in addition to the standard HS CAN bus. Unlike HS CAN, the MS CAN bus is not supported by standard ELM327 devices because it is a manufacturer-specific protocol using non-OBD2 standard pins. This ELM327 device has been modified to support MS CAN bus communication. HS CAN bus is supported by default, as Ford’s HS CAN complies with OBD2 standards and uses pins 6 and 14. MS CAN bus uses pins 3 and 11. Color: As shown Material: ABS Package Contents: 1 x Diagnostic Scan Tool Note: Only the items listed above are included; other accessories are not included