1.Gilt PCB and Small dimension and easy to embed into your project 2.Support I2C,SPI and HSU (High Speed UART), Change between those modes 3.Support RFID reading and writing. SupportP2P communication with peers. Support NFC with Android phone 4.Typical Operating Distance have been updated to 5cm~7cm reading distance<br><br>5.Work in NFC Mode or RFID reader/writer Mode 6.RFID reader/writer supports: 1) 1k, 4k, Ultralight, and DesFire cards 2) ISO/IEC 14443-4 cards such as CD97BX, CD light, Desfire, P5CN072 (SMX) 3) Innovision Jewel cards such as IRT5001 card 4) FeliCa cards such as RCS_860 and RCS_854 7.Plug and play, for Arduino compatible 8.Built in PCB Antenna, with 4cm~6cm communication distance 9.On-board level shifter, Standard 5V TTL for I2C and UART, 3.3V TTL SPI 10.Work as RFID reader/writer 11.Work as 1443-A card or a virtual card 12.Exchange data with other NFC devices such as smartphone Application : Here we introduce 3 basic example of this module. 1) Read/write RFID card As basic function, this module could read and write RFID card. Various cards could be supported. 2) P2P communication Two PN532 modules could communicate with each other wirelessly. 3) NFC with Andriod Phone The basic communication stamp with Andriod Phone (NFC supported) is finished. Colour:red Material: PCB<br><br>Package Contents: 1 x PN532 NFC RFID Module 1 x 2.54mm spacing 4pin Cable 1 x White Card 1 x One S50 Key Card 1 x 12P bended male pins<br><br>Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.