features: 1. The maximum power is 100W, and the compatibility is excellent.2. The version with USB adopts 5A high current PAL bus, with small internal resistance.3. Large volume ceramic capacitor filter, TVS anti surge anti reverse connection, Japanese ALPS touch switch, focusing on stability.4. With USB welding position and 5.08 screw terminal welding position, it is convenient to make Type-C to DC adapter cable.5. Small size: 15mm wide x 30mm long. After welding the DC wire, the shrink fit tube can be used to charge your notebook with the PD mobile power supply.Specifications:Voltage: 3-20VCurrent: 0-5Acolor:greenMaterial: PCB+ metalSize:3 x 1.5 x 0.5cmindustrial specification:The withstand voltage between any two industrial terminals is plus or minus 20V, and the input voltage is anti reverse connectedEffectively prevent problems such as VBUS short circuit to CC burning during testing.It is very suitable for testing the bare power module directly with the flying probe of the test fixture, and it does not need to be aembled before testing.Or DIY fast charging decoy line with plug, without hardware switch, it is not easy to touch and change the voltage by mistake.If the 5A-EMARK cable DIY is used, the maximum power is 100W, and the compatibility is excellent.The hole spacing is 2.54mm, which is convenient for the welding pin to be inserted into other motherboards.Connecting the TRIG pin to the ground is equivalent to preing the key, which can be triggered by optocoupler or relay isolation.If CC1 or CC2 is connected to the male connector, only one of them needs to be connected.Other operations are the same as the normal version.Package Contents:1 x ModuleOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.