Pcsensor LAN563V Network Type Voltage Detection LAN563V

Pcsensor LAN563V Network Type Voltage Detection Remote Control Phone Monitoring Record Data Sheet 1. Power supply mode: POE or USB 2. Device power: less than 1.5W 3. Working voltage: 5V 4. Working current: less than 300mA Factory default parameters 1. Username: Pcsensor 2. Password: admin 3. IP: 192.168.1.188 4. Gateway: 192.168.1.1 5. Subnet mask: 255.255.255.0 6. Port: 5200 7. Web page refresh interval: 5 seconds 8. Website URL: http:192.168.1.188:5200 (equipment supports secondary development, please consult sales staff for details) Product use: If the user is just starting to use the device, please follow the steps below: 1. Access the probe There are 2 types of voltage measurement modes for the device, namely single-ended measurement and differential measurement. 1.1. Single-ended measurement: Voltage range: 0 to 40V, accuracy 0.05V When using single-ended measurement, the device can measure up to 4 voltages at the same time, and the ground wire of the device must be connected to the ground wire of the measurement signal. 1.2. Differential measurement: Voltage range: -40 to 40V, accuracy 0.05V When using differential measurement, the device can measure up to two voltages at the same time. The ground wire of the device does not need to be connected to the ground wire of the measurement signal. It is only necessary to connect the two test leads under the same probe to both ends of the signal to be measured. 2. Access the network cable Use a network cable to connect the device to the computer, and modify the network parameters of the computer to: IP: 192.168.1.100 (the last digit is not 188); subnet mask: 255.255.255.0; gateway: 192.168.1.1 3. Plug in USB power 4. Open the software 4.1. After opening the software, it will pop up whether to load historical devices, select No 4.2. Then the Add Device dialog box will pop up, enter the IP and port of the device, the factory default IP is 192.168.1.188, and the port is 5200. Then click "OK" to add the device 5. Enter the dev